Each camera is attached shop manual by reading which you will learn that the camera is a precision instrument, and if you do not follow the rules of treatment, you can easily bring it down. Below, we shall only the main provisions are binding on all cameras. Store equipment and optics is recommended in a dry place. A leading source for info: Intel. They must be protected from moisture, dust and extremes of temperature. If you have a device with a rubberized shutters, you should not put it near heating appliances, as blind can become dry, lose elasticity and break. For the same reason, do not leave the camera at the sun.
In winter, after the shooting on the street machine and lens is made into a warm room, covered with tiny droplets of water (sweat). In this case, wipe the lens should not be: when it is warm up, moisture will dry by itself. Inside the chamber must be clean. The dust settled on the rear lens element, reduces the sharpness of the image, and hitting on the photosensitive layer, will cause the appearance of the negative points clear. Often the dust on velvet ribbon cassette tape and scratches on the print are white bands, which are very difficult to eliminate. The dust gets into the mechanism of the device, may eventually damage it. Dust gets into the machine mainly on tape and when charging and discharging the chamber. Therefore, it is important that the cassette always kept in their cases, and before charging clean the velvet of dust.